Fault diagnosis of marine diesel engine intake and exhaust system based on dynamic feature fusion北大核心CSCD

[目的]船舶系统由多设备的复杂机构组成,各组件参数具有动态性和非线性的特点,所以故障诊断过程复杂。为提高诊断效率,提出一种动态特征融合方法。[方法]利用分形理论、动态理论及核主元分析(KPCA)法对系统状态数据进行重构、映射及筛选,得到主元特征数据矩阵,求得平方预测误差(SPE)及相应的控制限,构建出基于船舶柴油机进排气系统健康数据的离线监测模型,利用该模型对系统进行故障诊断分析。为验证模型的有效性,选取某船舶柴油机进排气系统的故障数据进行验证分析。[结果]结果表明,动态特征融合分析方法可有效实现对系统动态非线性状态数据的精确分析,实现对系统故障的高效分析和诊断。与KPCA及支持向量机(SVM)方法相比,所提方法具有更好的故障诊断性能。[结论]该方法可实现船舶柴油机进排气系统故障的检测和诊断,提升系统运行的可靠性和安全性。     

Development and prospects of initial alignment method for strap-down inertial navigation system北大核心CSCD

Initial alignment technology is directly related to the navigation accuracy and startup time of the strap-down inertial navigation system (SINS), and has always been regarded as a challenging focal point in the research field of inertial navigation. This paper makes a comprehensive survey of SINS initial alignment technology, briefly introduces the basic principles of initial alignment without latitude, coarse alignment with known latitude and precise alignment, and points out their advantages, disadvantages and applicable conditions. The research and effects of existing initial alignment error suppression techniques are then analyzed and discussed. Finally, according to the problems of existing initial alignment methods and the development requirements of the carrier, the future research direction of SINS initial alignment technology is predicted. © 2022 Journal of Clinical Hepatology. All rights reserved.     

Influence of initial heeling angle on ship roll motion response北大核心CSCD

[目的]系统地研究初始横倾角对随机横浪下船舶横摇运动响应的影响。[方法]以路径积分法为基础,通过数值求解控制横摇运动微分方程概率属性的Fokker-Planck方程,得到横摇运动响应的概率分布。[结果]结果显示,初始横倾角对船舶横摇运动响应谱的影响有限,但对横摇角概率分布以及横摇运动响应极值分布的影响十分明显,且会造成船舶安全性的显著恶化。[结论]路径积分法可作为研究随机海浪下船舶横摇运动特性的有效数值方法。     

Research progress and application of computational method for hydrodynamic noise from air-water interface北大核心CSCD

含水气界面水动力噪声是船海工程结构物经常遇到的一类典型重要噪声,具有机理复杂、声源形式多样、传播影响因素众多等特点。含水气界面水动力噪声与自由面相互作用,受空化、水气泡混合流等影响,对舰船的隐蔽性造成很多负面影响,具有重要的研究意义。分别从自由面噪声、空化噪声和水气泡混合流噪声3个方面进行介绍,并阐述相应噪声的计算方法以及在噪声计算时需要考虑的关键问题和目前所采用的解决方案。最后,展望未来的研究发展方向。     

基于核磁共振与无侧限抗压试验对纤维加固红黏土的宏微观特性研究

红黏土因其具有孔隙比大、易压缩等不良工程特性,常在工程建设中引起一列工程问题.为此,采用聚丙烯纤维对红黏土进行加固,并采用核磁共振(NMR)技术和无侧限抗压强度试验对不同含量纤维加固后土体的宏微观特性进行测试,得到以下结论:1)不同含量纤维加固后红黏土的T2谱形态基本保持一致,均在弛豫时间为1 ms附近出现峰值,且纤维含量为0.2％时,试样内部信号最强;不同含量纤维加筋土内部的孔径主要分布在0.01μm到0.05μm之间,且0.02μm孔径所占比例最大;试样的孔隙度和T2谱峰值面积随纤维含量的增加表现出先增加后减小的趋势,且均在纤维含量为0.2％时到达最大值;2)纤维能够明显增加红黏土的抗压强度,加筋土的抗压强度与纤维含量保持良好的线性增加关系;且随着纤维含量的增加,试样由脆性破坏逐渐表现为韧性破坏特征.3)纤维在土体中起到加筋作用,显著增加了土体间的连接力,且纤维相互交叉连接形成了空间网状结构,限制了土体的变形,使得加筋土抗压强度增加并表现出韧性破坏特征.     

Are millennials more multimodal? A latent-class cluster analysis with attitudes and preferences among millennial and Generation X commuters in California

Transportation - Millennials tend to use a variety of travel modes more often than older birth cohorts. Two potential explanations for this phenomenon prevail in the literature. According to the...     

在建盾构隧道突发管片破损病害成因分析及治理措施研究北大核心CSCD

盾构法广泛应用于我国城市轨道交通隧道的建设中,盾构管片的病害问题也越发受到重视。文章针对某地铁在建盾构隧道突发管片破损病害,绘制了管片破损病害展布图,分析了相关资料和检测数据,明确了病害的成因机理,制定并实施了相应治理措施。研究结果表明:管片背后大范围空洞导致围岩对隧道的约束不足,引起已成型隧道在盾构机反推力和扭矩、同步注浆浆液浮力、刀盘水土压力和扭矩等作用下发生类压杆弯扭失稳是导致该病害的主要原因;隧道变形监测数据表明"背后注浆填充+破损部位修复"两阶段治理措施取得了良好的治理效果;盾构隧道施工过程中,应严格管控同步注浆质量,防止隧道轴线偏移引起盾构管片发生开裂破损等病害。     

Distributed support modelling for vertical track dynamic analysis

The finite length nature of rail-pad supports is characterised by a Timoshenko beam element formulation over an elastic foundation, giving rise to the distributed support element. The new element is integrated into a vertical track model, which is solved in frequency and time domain. The developed formulation is obtained by solving the governing equations of a Timoshenko beam for this particular case. The interaction between sleeper and rail via the elastic connection is considered in an analytical, compact and efficient way. The modelling technique results in realistic amplitudes of the ‘pinned–pinned’ vibration mode and, additionally, it leads to a smooth evolution of the contact force temporal response and to reduced amplitudes of the rail vertical oscillation, as compared to the results from concentrated support models. Simulations are performed for both parametric and sinusoidal roughness excitation. The model of support proposed here is compared with a previous finite length model developed by other authors, coming to the conclusion that the proposed model gives accurate results at a reduced computational cost.     

绞吸挖泥船柴油机排放性能的优化

针对绞吸挖泥船柴油机在香港国际机场第三跑道3206标段回填工程中排放性能不达标的问题,对“天滨”绞吸挖泥船的16V240ZC型柴油机排放问题进行分析,重新匹配增压器,改造冷却水系统,增加VTG（增压器可变喷嘴）电子控制系统,并进行实船应用。结果表明,改善后的柴油机的空燃比得以优化,燃烧效率提高,油耗降低3%,烟度值FSN从0.61下降到0.40以下,改善了排放性能。     

The planning and analysis of a new group rapid transit system: the SkyCabs monobeam system in Auckland

This paper examines a case study of the SkyCabs system as a way to alleviate some of the traffic problems of Auckland, New Zealand. SkyCabs is an elevated two-way monobeam carrying light eight-seater cabs on tracks on each side of the beam, available on demand, providing fast, pollution-free, unimpeded travel above the footpath with panoramic views of the city. The aim of this study is to investigate the attractiveness of implementing the SkyCabs system to and from Auckland central business district (CBD) and Auckland international airport by examining four variables: different routes, different number of stops/stations, different passenger demand levels, and different number of cabs in the system. The analysis utilizes geographical information system and simulation tools for the various scenarios considered. The results show that it is possible to assess the cost–benefit of alternative routes in terms of those four variables and rate of return on investment.